All Information about USB or UTB

USB Extender Extend USB cable with UTP Cable

 

Why do we need a long USB cable? Because USB cables are available in the market is usually a maximum of only 1 to 1.5 mtr. Although actually there are 10-20 meters, but there are rare and usually requires a USB repeater (klo ga wrong it's called) to strengthen the flow of data in the USB that long. the problem is the USB repeater price is quite expensive for me to buy, luckily there is a solution by extending a USB cable using UTP cable. Because of its extended klo USB cable with UTP for 20 mtr most likely still be without a USB repeater (though it still depends on the same USB in motherboard too). Usually need a long USB cable is used for the installation of a USB WiFi antenna outdoor, extended printer cable, USB HUB, etc ...

Disaranakan using USB ver 1.0, because based on experience. This trick almost always works on a USB ver 1.0

Well, we live in practice only. Materials and equipment that need to be prepared are:

1.Kabel UTP, his long suit. But I suggest no more than 20 meters. If more than 20 meters, it will take a usb repeater / usb extender to strengthen the flow of data and power.

USB 2.Kabel

3.Rubber tape

4.Thermofit / condom cable (optional)

5.Pipa small pvc

6.Gunting

7.Solder

After all the ingredients prepared, the first thing to do is peel UTP cable on both ends of it. And is divided into 4 parts as shown below. His division, the cable joined orange on a white cable-orange, white, blue, green and the rest of the 4 wires combined into one.

Furthermore, usb cable that had been prepared earlier cut manjadi 2 parts.

Then ujung2nya in peel.

The next stage, insert a small pvc pipe / pipauntuk protective connection to each end of the UTP bakel

And, as well as in parts of its usb cable. Enter the condom wrapper on each section cable USB cable.

Next, connect the UTP cable with a USB cable, with a sequence like the picture below, it is recommended to use solder, because of my experience when not using solder, a USB device is not detected by the computer, despite being set to USB version 1.0:

After all the cables are connected, wrap the connection using a condom cable / thermofit.

And after that, the wrap had a connection with a small pvc pipe.

Now, the USB cable is ready to be used for antenna Wajanbolic using USB WiFi / USB WLAN .